Three Channel Rotary Dryer for wood chip

If you interesting in Three Channel Rotary Dryer for wood chip,
Ask me freely by email/whatsapp/Skype, Shandong industrial microwave oven can give technical support and service.
Please metioned below information in your enquriy.
1.What's your raw material? How about the form of your products?
2.How much moisture content before drying and after drying?
3.How many input and output capacity per hour?
Once confirm above details,we can provide a suitable solution for you.

In addition,Shandong industrial microwave oven not only manufacture Drying Equipment ,but also have oil press and refined oil equipment for peanut, soybean, rapeseed, cottonseed, sunflower, sesame, animal,grape seed, acer truncatum, peony seed, walnut, hemp seed, pine, tea seed, papaya, milk thistle seed, and other special material.

Expect to help you and cooperate with you in near future.

Contact Shandong industrial microwave oven
Miss Jessica
Skype: leaderfoodmachine1
Mobile: +86 15964025360 (Also WhatsApp & Wechat)
Email: [email protected]

Three Channel Rotary Dryer for wood chip

Three-cylinder Three Drum rotary dryer is mainly applied for stoving slag, sand, coal, fly ash, iron powder, ore, quartz sand and other particle materials. It has the following characteristics:

1. The cylinder protect itself, thermal efficiency can up to 95%.The whole length of the dryer reduced to 50% approximately than mono-cylinder and reduced land investment to 50% approximately

2. Cylinder adopts heat-resistant and wear-resistant steel plate welding with long service life and easy maintenance..High thermal efficiency , temperature of outer cylinder is 60or below(temperature of outer mono-cylinder is high to 150°C)

3. low temperature of outlet, long-service of dust removal machine. It also can be directly connected to air box pulse bag filter.

4. Without gear and pinion drive, but wheel rotation applied, level operation of the complete machine makes system simple and reasonable.

5. Air heater could match boiling furnace, or oil furnace can also be applied, which can dry materials with size below 20mm.

6. Final moisture index can be adjusted according to requirements of customers.

Working Principle:

Sand sent into hopper by the conveyor and bucket conveyor, then the material pass through the feeding tube into the feed end . The gradient of feeding tube must be greater than the natural angle of materials, so that the material can enter into sand dryer. The desiccators' cylinder is an oblique rotating drum. Heat-carrier enters into the dryer from the low-end that can form reflux with the material added from the upper end. With the rotating of cylinder, materials are carried to the bottom end by gravity. In the moving process, wet materials obtain the heat input of heat carrier indirectly to be dried. Then, the finished materials are sent out by belt conveyor and screw conveyor, the wall plate of cylinder body can lifting the materials up and down, increasing the contact area of material and air flow to improve the drying rate and promote the progression of materials. The heat carrier is generally classified into the hot air flue, gas flue,etc. Dust cyclone need to capture down the materials carried by gas. If the dust content of off gas needs to be reduced in further, Bag filter or wet dust also should be used.

Technical Parameters: