Microwave Liquid Sterilization EquipmentTL-15

If you interesting in Microwave Liquid Sterilization EquipmentTL-15 ?kindly ask me, Shandong industrial microwave oven can give technical support and service.
Please metioned below information in your inqury.
1.What's your raw material? How about the form of your products?
2.How much moisture content before drying and after drying?
3.How many input and output capacity per hour?
Once confirm above details,we can provide a suitable solution for you.

In addition,Shandong industrial microwave oven not only manufacture Microwave equipment ,but also have oil press and refined oil equipment for peanut, soybean, rapeseed, cottonseed, sunflower, sesame, animal,grape seed, acer truncatum, peony seed, walnut, hemp seed, pine, tea seed, papaya, milk thistle seed, and other special material.

Expect to help you and cooperate with you in near future.

Contact Shandong industrial microwave oven
Miss Jessica
Skype:leaderfoodmachine1
Tel:+8615964025360 (WhatsApp&Wechat)
Email:[email protected]

Microwave Liquid Sterilization Equipment divided into two kinds, one kind is with packaging sterilization of liquid, but except for metal packaging, because microwave can penetrate the metal.Before the second category is the liquid filling without packaging sterilization, liquid pipeline through the microwave cavity, liquid heating to a certain temperature after sterilization to filling machine for filling.
Use of microwave heating and microbial response effect of microwave radiation, for all kinds of materials for 60 °C, 100 °C low temperature sterilization and drying, to minimize the loss of original component materials.Compared with other sterilization drying method, the effect is good, high efficiency, low cost, no pollution.
This equipment adopts the cooling system of water-cooling refueling cold, to ensure that the equipment steadily run continuously for a long time.
Due to the equipment at work, magnetron can produce high temperature, cooling is not good, will burn magnetron or affecting the service life of magnetron.Equipment need eight hours at work and even shift constantly high strength run continuously, then the magnetron cooling is very important.At the same time, the continuous high voltage transformer is in a working state, the temperature rising.Transformer extreme working conditions, external power supply environment and equipment start-up, magnetron open/close, etc., can cause transformer overload, further increases the burden of the temperature of the transformer.Therefore, magnetron, transformer burned became frequent common fault phenomena of the general equipment.
General equipment in order to reduce costs, to the magnetron and transformer adopts wind cooling method, however, the cooling efficiency of air relative to water, is quite low, the harm of magnetron and transformers can be deadly.Air cooling in a short period of time don't see much of a problem, but, after a period of time after the operation of the magnetron and transformer is washed-up, frequent burned a vicious cycle of change will come.And magnetron and transformer is an important part of a more expensive, the cost.
My company's equipment, adopt PLC automatic control technology, touch screen programming user can according to need to be flexible design change process.
Equipment adopts full stainless steel manufacturing, process design and processing according to the requirements of GMP standard.

The following equipment is specially made for China customer—A famous pharmaceutical factory,being used for sterilizing the liquid health care products.